Jason

15 j link to AMCD appears to be dead. It would never start the d/l phase.

Steve

Sorry ooops was on my end and not yours!

I have d/l 15j and installed it over 15g. After loading into AM the models were so bright I could not see them. Totally washed out. Has anyone seen this happen? I also did a clean install and the same thing.

Steve

Wow it was the direct 3d replaced the open gl. I d/l the new drivers and reset to opend gl.

Thanks Stefen for the update. Some of the issues have been resolved and I am not sure but the sss rendering and rendering in general seems to be faster.

Steve