Dang it's hard being an old fart, I even wrote this down, but I lost it. (Little brother: You lost it decades ago. Me: Shut up, little brother.)

Instead of making bevels on everything, there's a way to reset a property so the spline curves are sharper at the control points. Sorta halfway to peaked CP's. It was covered on the forum a little while ago. Would some kind soul point me in the right direction?

Gently, please, I get dizzy if you spin me too fast.

Do you mean adjust the bias? Select the cp and in it's properties you can set the bias magnitudes to 50%.

Dot may be it. I'll play with it some and see what happens. Gracias.